NexStarCtl version 0.13 ======================= This module implements the serial commands supported by the Celestron NexStar hand control. This applies to the NexStar GPS, NexStar GPS-SA, NexStar iSeries, NexStar SE Series, NexStar GT, CPC, SLT, Advanced-VX, Advanced-GT, and CGE mounts. Communication to the hand control is 9600 bits/sec, no parity and one stop bit via the RS-232 port on the base of the hand control. Communication can be established over TCP/IP if nexbridge is running on the computer connected to the telescope. INSTALLATION To install this module type the following: perl Makefile.PL make make test make install DEPENDENCIES Device::SerialPort Time::Local COPYRIGHT AND LICENCE Copyright (C) 2013 by Rumen G.Bogdanovski This library is free software; you can redistribute it and/or modify it under the same terms as Perl itself, either Perl version 5.12.4 or, at your option, any later version of Perl 5 you may have available.